iPhone screen goes blank when it eats hard and sensitive blows on the key areas of the phone. You will panic normally to see their costly mobile phone going numb and showing up nothing out of anything at all suddenly. You will wait no other minute to take it to the apple service center and to get it repaired. This will cost you some extra bucks causing distress over your selection of idevice over several other handsome handsets.
But don’t do that in a hurry! wait a minute before you take it to a technician. Realize the fact that it has gone repair and it will cost you something anyhow. Then why don’t you try out some DIY troubleshoots at first!
Lifesaver tip #1
Your iPhone might have gone blackout due to battery drain. This is because you might have not noticed it or maybe because of the latest iOS upgrade. It may also because you ran a heavy graphical or incompatible application on it. For such all these causes, you can get back your iDevice by putting it to charge for 10 minutes and trying switching it on again.Lifesaver tip #2
If the above trick doesn’t work, press and hold the Home button and Power button till the Logo appears. This will restart your phone by losing nothing on it.Restarting the phone after keeping it to charge for 5-10 minutes will help at most of the times. If that too doesn’t help you, try the following trick but, be careful, we are not responsible if you damage your phone.
Lifesaver tip #3(critical)
You will have to open up your iPhone in this trick. Just have to open up and reset the battery like thing in it and nothing more. It’s easy if you could just open it up, the phone’s back panel. Don’t worry I am going to guide you properly till the end, but be careful and don’t blame me or amfastech.com if anything goes wrong. Remember that you are one who is doing it, not us!Step 1: Get a iPhone liberation kit(Click here for iPhone 4 or 4s liberation kit or Click here for iPhone 5 or 5s liberation kit). It looks like as shown in the following screenshot:
Step 3: Now press the back cover slightly up with your two thumbs and remove it.
Step 4: You can see the battery and the screwdriver point is where the battery connects. Check it the battery looks fit in it.
Step 5: This is where the screen connector exits:
When you drop off your phone or give it a hard blow it might get loose sometimes and it might be the cause for the blackout problem.
Press it a little hard till you listen clutching sound just like you hear when you are fitting a back panel of a mobile phone.
That’s it!
Restart the phone using the method shown in tip#2.
Step 6(important): Set back the back cover & fix the screws back into the holes.
Post your smiles in comments below if this worked for you!
If it doesn’t, go for your first choice of taking it to the apple service center.
Post a Comment